Trim and steering, back in your control.
Wake repairs outboard power trim and tilt systems, steering and controls across South Florida, at your dock or driveway. That includes trim motors, relays, fluid leaks, steering stiffness and shift and throttle adjustment.
- Yamaha factory-trained
- Mercury factory-trained
- ABYC electrical certified

If this sounds like your boat.
Trim and steering problems usually start small: a motor that hesitates, a little fluid on the transom, a wheel that takes more effort than it used to. Fixing them early keeps the boat safe to handle and stops a minor leak from turning into a full rebuild.
- Trim won't go up or down, or only works one way
- Engine slowly trims down on its own
- Fluid leaking around the trim rams
- Steering is stiff, loose or uneven
- Shift or throttle feels sticky or out of adjustment
What we actually do.
Every job ends with a test run and a plain-English summary, with photos of what we found.
- 01Trim motor, relay and switch testing
- 02Trim fluid check, top-off and leak diagnosis
- 03Trim ram seals and rebuild when needed
- 04Hydraulic steering bleed and inspection
- 05Shift and throttle cable adjustment
Four steps, zero hauling.
- 01
Call, text or request a quote
Tell us the engine, where the boat is and what it's doing. A photo or video helps.
- 02
We come to you and diagnose
Dock, lift, slip or driveway. We test the engine where it sits and finds the real cause.
- 03
Clear quote before any work
You get the problem, the fix and the price in plain English. Nothing starts until you say go.
- 04
Fixed, tested, back on the water
Repaired, run and checked, with photos of what we found and what we did.
Factory-trained on the big two.
Wake is Yamaha and Mercury factory-trained, with 30+ certifications between them, and services Suzuki, Honda, Evinrude / E-TEC, Tohatsu outboards too.
Serving Fort Lauderdale, Davie, Miami, Coral Gables and nearby. See the service area
Why won't my outboard trim up?
The most common causes are low trim fluid, a failed relay or switch, a weak battery or a worn trim motor. Testing the circuit and the motor finds which one.
My engine trims down by itself. What's wrong?
That usually means an internal leak in the trim system, often worn seals or a valve. It's worth fixing before the engine trims down while you're underway.
Do you work on hydraulic steering?
Yes. We bleed, inspect and repair hydraulic steering, and check helm and cylinder condition.
Often done together.
Marine electrical (ABYC)
Batteries, charging, wiring, gauges and ignition. Traced properly and fixed to standard.
Learn moreLower unit & gearcase
Water in the gear oil, leaking seals, clunky shifting. Sorted before it eats the gears.
Learn moreDiagnostics & troubleshooting
Won't start, stalls, loses power or throws an alarm. Found and explained at your dock.
Learn moreKeep your weekends on the water.
Tell us what's going on. We'll tell you what it takes.
Prefer to text? Send a photo of the engine and what it's doing.
