Lower unit repair, without the haul-out.
Wake services and repairs outboard lower units and gearcases across South Florida, at your dock, lift or driveway. We handle gear lube service, seal replacement, pressure and vacuum testing, and shifting problems.
- Yamaha factory-trained
- Mercury factory-trained
- ABYC electrical certified

If this sounds like your boat.
The lower unit takes the hardest abuse on the engine: impacts, fishing line wrapped around the prop shaft, and constant saltwater exposure. Milky gear oil means water is getting in, and catching it early is the difference between a seal kit and a new gearcase.
- Milky, gray or watery gear oil when drained
- Metal flakes on the drain plug magnet
- Hard, clunky or slipping shifts
- Whining or grinding from the lower unit
- Fishing line wrapped around the prop shaft
- Oil leaking around the prop or drive shaft
What we actually do.
Every job ends with a test run and a plain-English summary, with photos of what we found.
- 01Gear lube drained and inspected
- 02Pressure and vacuum testing to find leaks
- 03Prop shaft and drive shaft seal replacement
- 04Shift linkage and shift cable adjustment
- 05Prop inspection and hub check
- 06Refill with the correct gear lube and leak check
Four steps, zero hauling.
- 01
Call, text or request a quote
Tell us the engine, where the boat is and what it's doing. A photo or video helps.
- 02
We come to you and diagnose
Dock, lift, slip or driveway. We test the engine where it sits and finds the real cause.
- 03
Clear quote before any work
You get the problem, the fix and the price in plain English. Nothing starts until you say go.
- 04
Fixed, tested, back on the water
Repaired, run and checked, with photos of what we found and what we did.
Factory-trained on the big two.
Wake is Yamaha and Mercury factory-trained, with 30+ certifications between them, and services Suzuki, Honda, Evinrude / E-TEC, Tohatsu outboards too.
Serving Fort Lauderdale, Davie, Miami, Coral Gables and nearby. See the service area
What does water in the lower unit oil mean?
A seal has failed somewhere, often at the prop shaft after fishing line gets wrapped around it. Water in the gear oil causes corrosion and gear wear. A pressure and vacuum test finds the leak, and replacing seals early usually saves the gearcase.
How often should I change the gear lube?
Most manufacturers call for it at every 100-hour or annual service. In saltwater it's worth checking any time you've hit something or picked up line.
Can you rebuild a gearcase or do I need a new one?
It depends on what's damaged. After inspection, we'll give you the cost to repair and the cost to replace so you can make the call.
Often done together.
Routine & 100-hour service
Oil, filters, plugs, gear lube, anodes and a full inspection. On schedule, on site.
Learn moreImpeller & water pump service
Overheat alarm or a weak tell-tale stream. Pump rebuilt before it cooks the engine.
Learn moreTrim, tilt & steering
Trim that won't move or won't hold, stiff steering, sticky controls. Fixed and adjusted.
Learn moreKeep your weekends on the water.
Tell us what's going on. We'll tell you what it takes.
Prefer to text? Send a photo of the engine and what it's doing.
