Impeller replacement at your dock.
Wake replaces outboard impellers and rebuilds water pumps at your dock across Fort Lauderdale, Miami and South Florida. If your tell-tale stream is weak or the overheat alarm is going off, the water pump is the first thing to check.
- Yamaha factory-trained
- Mercury factory-trained
- ABYC electrical certified

If this sounds like your boat.
The impeller is a rubber part that pushes cooling water through the engine. It wears with every hour, and sand, silt and long periods of sitting make it worse. When it fails, the engine overheats quickly, and overheating is how small repairs turn into powerhead damage. Replacing it on schedule is cheap insurance.
- Weak, sputtering or no tell-tale (pee) stream
- Overheat alarm or temperature reading climbing
- Engine goes into reduced-power mode
- You've run in sand, silt or shallow water
- The impeller hasn't been changed in a year or more
What we actually do.
Every job ends with a test run and a plain-English summary, with photos of what we found.
- 01Lower unit dropped and water pump opened up
- 02New impeller, and wear plate, housing and gaskets as needed
- 03Water tube and grommets inspected
- 04Tell-tale and cooling passages checked
- 05Test run to confirm cooling flow and temperature
Four steps, zero hauling.
- 01
Call, text or request a quote
Tell us the engine, where the boat is and what it's doing. A photo or video helps.
- 02
We come to you and diagnose
Dock, lift, slip or driveway. We test the engine where it sits and finds the real cause.
- 03
Clear quote before any work
You get the problem, the fix and the price in plain English. Nothing starts until you say go.
- 04
Fixed, tested, back on the water
Repaired, run and checked, with photos of what we found and what we did.
Factory-trained on the big two.
Wake is Yamaha and Mercury factory-trained, with 30+ certifications between them, and services Suzuki, Honda, Evinrude / E-TEC, Tohatsu outboards too.
Serving Fort Lauderdale, Davie, Miami, Coral Gables and nearby. See the service area
Common questions, plain answers.
Got a photo of the problem? Text it to us
How often should an outboard impeller be replaced in Florida?
Many manufacturers suggest inspecting or replacing it every year or two, or sooner if you run in sandy or shallow water. In South Florida saltwater, replacing it during your annual service is a smart habit.
Is it safe to keep running if the alarm went off?
No. Shut down, let it cool and get it looked at. Running an overheating outboard can damage the head gasket, pistons and powerhead.
Can this be done with the boat in the water?
Often yes, on a lift or trailer. For some setups the lower unit needs to come off with the boat out of the water. We'll tell you what your boat needs when you book.
Often done together.
Routine & 100-hour service
Oil, filters, plugs, gear lube, anodes and a full inspection. On schedule, on site.
Learn moreLower unit & gearcase
Water in the gear oil, leaking seals, clunky shifting. Sorted before it eats the gears.
Learn moreDiagnostics & troubleshooting
Won't start, stalls, loses power or throws an alarm. Found and explained at your dock.
Learn moreKeep your weekends on the water.
Tell us what's going on. We'll tell you what it takes.
Prefer to text? Send a photo of the engine and what it's doing.
